Magicbond Tile Laying Adhesive

MagicBond Tile Laying Adhesive range is a polymer modified grey/white cement based adhesive for fixing all types of tiles on floor and walls suitable for both internal and external applications. It provides excellent water proofing properties and resists cracking of titles.

Application Areas Tile Adhesive-120 Standard Tile Adhesive-121 Elite Tile Adhesive-122 White
Internal Walls Yes Yes Yes
External Walls Yes Yes Yes
Flooring Yes Yes Yes
Ceramic Tiles Yes Yes Yes
Vitrified Tiles Yes Yes Yes
Cladding / Walls - Yes Yes
Stones - Yes Yes
Glass Mosaic - Yes Yes
Marble - - Yes
Granite - - Yes
Download MagicBond Tile Laying Adhesive Brochure


High Bond Strength

MagicBond is prepared with proprietary technology and the polymeric additives and binders ensure that the high bond strength (>3.4Mpa) is achieved leading to superior masonry strength and excellent load-bearing capacity.

Thermal Insulation

Thin joints prevents heat transfer through walls.

Zero Wastage

It is easy to apply and avoids wastage of material.

No Shrinkage Cracks

Water is retained in mortar which prevents Shrinkage Cracks.

Economical & Time Saving

Reduced construction timeline also reduces the direct cost of labor along with overhead costs. The volume of the dry-mix mortar is considerably less than the traditional mortar bringing down the cost significantly. A 40kg MagicBond bag covers almost 200-225sq ft of surface area with a 3mm thickness.


No jobsite blending of powder is required. Only water is to be added.

Preparation & Application

  • The application surface shall be rigid, and free from oil, grease, paint, loose plaster or any other dirt particles.
  • Dampen the wall before application of adhesive (for cladding application).
  • Clean the back of tile for any dust or coating.
  • Pour 5 - 6 liters of potable water in a clean container and then add 1 bag (30 kg) of Magicbond Tile Adhesive.
  • It can be mixed by hand or slow speed electric drill mixer.
  • Leave the mix to slake for 5- 10 minutes and remix before use.
  • The adhesive shall be applied with the flat side of the trowel using a scraping motion.
  • Additional mortar is then applied with the notched edge of the trowel.
  • Ensure that tile is completely bedded in the adhesive.
  • Excess adhesive shall be cleaned from the rear surface of the tile with a damp sponge.